For the majority of people, either 16 gauge or 14 gauge is a good starting point if you have only worn regular earrings. 16 gauge is a good starting point if you never wear earrings or if you have recently had them pierced and they are just healed up.
Likewise, people ask, how do you stretch a piercing?
Simply wrap one layer (or more) of tape around the jewelry and re-insert it into the piercing. You will repeat this method over time, gradually adding more tape and thus increasing the size of the hole. But not just any tape will do. What you are using to wrap should be inert and free of adhesives.
Furthermore, how long do you leave tapers in before putting plugs in?
Generally, you need to wait at least 3-4 months before gauging the fresh plug piercing, after it’s initially done. Then, you‘ll have to take breaks of at least 1 month between other 1-sized stretches.
Can I start stretching my ears at 10g?
There is no such thing as stretching too slowly, but stretching too quickly can cause scarring, injury, and prevent ears from healing evenly and properly. Find out what size your earlobe piercings are. Most standard piercings start at 16g or 14g, but can be done bigger by request.
How long does it take to stretch ears to 00?
roughly two years
Can I put a 20g in a 16g piercing?
Yes you can, in fact that’s typically what a piercer will do, especially with cartilage piercings. … Generally a piercer will use an 18f needle and use a 20g stud if it’s your ears for example. Take a look at this photo for example: The difference between 16g and 18g is about .
Can I put a 16g in a 14G piercing?
Yes all day you can. However, the 16g post is thinner than the 14g. Downsizing is not an issue unless you’ve got a large collection of 14g jewelry that you wish to wear again. Downsizing to 16g is safe as long as it is healed.
Why is the jump from 8g to 6g so big?
It’s probably for 2 reasons. First off, there’s a larger size jump between 8g and 6g. Up until 8g, there is only a difference of 0.6mm or less in between each size. After 8g, the differences get larger, and there is a 1 mm size difference between 8g and 6g.
Should I take my plugs out at night?
No problem either way. If you go without plugs at night, your holes will tighten. If you find that you’re jewelry starts to get loose and you don’t want to upsize, then sleeping without jewelry will help keep them from self-stretching. … Sometimes they do fall out while I sleep since they’re so loose.
Can I leave tapers in overnight?
If it’s too tight, what you’ll do is tear the skin off the inside of your hole. This is painful and incredibly unpleasant and bloody. Repeat until you get the taper all the way in. Leave it for at least a couple of hours, ideally overnight.
Can I sleep with tapers in?
Thank you! Tapers are easy to knock in your sleep and you can rip your ear. Put in a pair of plugs. And tapers are only meant for inserting jewelry, not for stretching.
Can you put tunnels in right after stretching?
To stretch with tapers, the first thing you need to do is wash your hands and anything going in your ear lobe. … You don’t need to rush through this process, but your ear should stretch pretty easily. 4. Once you have the taper through, you‘ll put the plug in right after.
Can you put plugs in right after tapers?
Wait for your ear piercing to fully heal (no swelling, discharge, itching, etc.). … Put your plug at the thicker end of the taper so you can insert it into the stretched piercing immediately. Insert your plug into the hole once the taper goes all the way through.
How many mm is 9/16 gauges?
Ear Gauge to MM Conversion Table
| Millimeters(mm) | Inches |
|---|---|
| 14 mm | 9/16“ |
| 16 mm | 5/8″ |
| 19 mm | 3/4″ |
| 22 mm | 7/8″ |
