Most people’s ears are suitable to get an industrial piercing. However some people’s ears don’t have a prominent ridge on the upper part of the ear. If your ear has a prominent ridge that runs from the upper part of the ear to about midway then you should be able to get an industrial no problem.
In respect to this, how bad does an industrial bar piercing hurt?
Industrial piercings are moderately painful. While they tend to hurt more than standard lobe piercings, they’re still much less painful than piercings on more sensitive areas. … The initial piercing pain is a sharp pain, like a hard pinch, and you may also experience some pain as the jewelry is pushed in place.
Beside this, what is an industrial ear piercing?
An industrial piercing (North America), sometimes called a scaffold piercing (UK/Ireland) or construction piercing, is any two pierced holes connected with a single straight piece of jewelry (compare to orbital piercing); however, it typically refers to a double perforation of the upper ear cartilage specifically.
Does Claire’s do industrial bar piercings?
Gold Key Industrial Bar Cartilage Earring | Claire’s.
Are my ears too small for an industrial piercing?
If you have a smaller ear, you might not be able to accommodate the industrial piercing. … If you’ve had problems healing cartilage in the past, then it’s a good idea to talk to your piercer before pursuing the industrial piercing.
How much does an industrial piercing cost at Claire’s?
Ear Piercing is FREE with the purchase of a starter kit. Starter kits are priced from $30 and include the piercing earrings or stud, and standard aftercare solution. Ear cartilage piercing is subject to an additional charge.
Are industrial piercings hard to heal?
The difficulty of an industrial piercing to heal also makes it much more painful in the long run. You’ll find that it is tender for longer than most other piercings and because it is more likely to get infected your healing time may be longer.
What hurts more Daith or industrial?
Personally, daith hurt more for the initial piercing, but industrial has been way worse for healing. If you do get another piercing though, wait until the industrial is healed enough to sleep on.
Are industrial piercings dangerous?
Industrial Piercing Risks
As long as you do double the work and don’t try to cut any corners though when it comes to aftercare, you can cut down on some of the risk. With two piercings being done on the cartilage instead of skin, you do have a slight risk of excessive bleeding.
Are industrial piercings worth it?
Industrial piercings look absolutely awesome, but you have to take very good care of them. Cartilage piercings generally take longer to heal, and an industrial is two piercings rather than one. … Before the piercing, be sure to tie back your hair if it is long, so the piercer can see your ear.
Do industrial piercings get infected easily?
Industrial piercings are more prone to infection because there are 2 wounds, and the tension placed on the skin from the jewelry also increases inflammation and vulnerability to the skin. An infection occurs when harmful bacteria build up in one or both of the holes where your ear is pierced.
What do you clean industrial piercings with?
Industrial piercings can easily become infected if they are not properly cleaned and cared for. You should clean an industrial piercing twice daily with antibacterial soap or with a solution of warm water and sea salt for the entire healing period.
Can you sleep on an industrial piercing?
Sleeping with your piercing on the pillow means pressure over an extended period of time. This can cause irritation, pain, and swelling. If you tend to sleep on your side, your best bet is to pierce one ear at a time. … This allows you to put your ear in the hole, so you can rest on your side without irritation.
