This is a popular piece of body jewelry because it conveniently allows the wearer to remove the ring by simply removing the captive bead, the bead is held firmly in place so that it will not easily fall out.
Similarly one may ask, how do captive rings work?
Traditional captive bead rings, or CBRs, hold a bead in place using the ring’s own tension/pressure. The rounded ends of the captive bead ring fit into two little dimpled indentations on either side of the captive bead to hold it in place.
Besides, how do you expand a captive bead ring?
Hold the ring steady with your free hand and push the captive bead into the open segment of the ring. The captive bead should pop into place. If the open segment is too narrow, you can use the ring opening pliers to expand it slightly.
How do I get captive beads back in?
How do you open a captive bead ring without pliers?
Captive Bead Ring Removal
- Grab the jewelry by ring with the index and thumb of one hand.
- Grab the bead or ball with the index and thumb of the other hand.
- Pull and apply force in opposite directions causing the tension that the ring has on the ball or bead to break.
- Once the ball or bead is free, rotate the jewelry out.
How do you open a septum ring with a ball?
Firstly the ball may be pulled out by hand by forcing the ball from the ring or by gently twisting the ring. The best method is to use long nose pliers or preferably BCR / Circular barbell opening pliers. By placing the pliers through the ring and VERY GENTLY opening them until the ball is released.
How do you unscrew a stuck ball piercing?
A pair of latex or rubber gloves will usually provide enough grip to unscrew a stuck piercing ball. Make sure the jewelry is completely dry and grab the ball with your gloved hand. The bit of extra torque from the rubber gloves might provide just the right amount of traction to get your ball unstuck.
How do you take out a septum ring with a ball?
Grasp either of the balls between the forefinger and thumb of the left hand. Grasp the ball on the opposite side of the barbell in the same manner with the right hand. Twist the ball in your right hand counter-clockwise to loosen it. Continue to turn the ball until it comes off completely.
Can I put a 14G in a 16g piercing?
14g jewelry is larger than 16g jewelry, but you might be able to fit it. Yes, you can stretch you piercing to a 14g just make sure that the jewelry that you’re buying is suitable for a freshly stretching piercing. … It would just irritate the piercing even if it is fully healed.
Can you put a 16g earring in an 18g hole?
If I pierce with a 16g needle, can I use 18g jewelry? Yes you can, in fact that’s typically what a piercer will do, especially with cartilage piercings. They pierce with a gauge size bigger than the actual jewelry. It allows room for swelling and placing the jewelry.
Is 14G bigger than 16g?
Jewelry is measured through a gauge system (see chart below). The higher the gauge number the smaller the wire is. A standard “earring” is usually 20 gauge. Jewelry gauges/sizes can vary between manufacturers.
| Gauge | Millimeter | Inch |
|---|---|---|
| 16g | 1.2mm | 3/64″ |
| 14g | 1.6mm | 1/16″ |
| 12g | 2mm | 5/64″ |
| 10g | 2.4mm | 3/32″ |
