General Care for Body Piercings
Always wash hands thoroughly before contact with piercing. Do not use rubbing alcohol or hydrogen peroxide. (Both slow the healing of pierced area by drying and killing new healthy cells.)
Beside this, what can I use to clean my ear piercing?
New Ear Piercing Care:
Use a cotton swab (Q-tip) with salt water to clean the area around the hole twice a day. Some recommend using hydrogen peroxide, rubbing alcohol, or antibiotic ointment but salt water disinfects and is less damaging to the skin tissue.
- Wash your hands before touching or cleaning your piercing.
- Clean around the piercing with a saltwater rinse three times a day. …
- Don’t use alcohol, hydrogen peroxide, or antibiotic ointments. …
- Don’t remove the piercing.
Subsequently, how do you disinfect a piercing?
Do
- choose a qualified, experienced and licensed piercer.
- clean your piercing twice a day.
- use warm, salty water to soften any crusting.
- gently turn the jewellery while cleaning the piercing.
- use a clean paper towel to dry the piercing.
- gargle with salty water or an alcohol-free mouthwash if you have a mouth piercing.
What to use to clean new piercings?
Clean with a clean cotton pad or swab dipped in salt solution. You can make this solution by mixing 1 teaspoon of salt in a cup of warm water. Use this around the pierced area a few times a day to remove any bacteria. Dab (don’t wipe) the piercing.
Which is better rubbing alcohol or peroxide?
In general, rubbing alcohol is better at killing germs on your hands, as it’s gentler on your skin than hydrogen peroxide. Hydrogen peroxide is most effective when it’s allowed to sit on surfaces for at least 10 minutes at room temperature.
How can I make my piercing heal faster?
USE WARM SEA SALT WATER (SALINE) SOAKS – MORNING AND EVENING
Soaking your piercing with a warm, mild sea salt water solution will not only feel good, it will also help prevent infection, reduce the risk of scarring, and speed the healing of your piercing.
What is the best saline solution for piercings?
Do not use table salt, kosher salt, Epsom salts, or iodized sea salts. Non-iodized fine-grain sea salt is best for avoiding additives, as well as its ability to dissolve into a solution. Do not make the solution too salty, as that can be irritating to the piercing and the skin.
How do you sleep with a newly pierced ear?
If you have a new ear piercing, a thinner travel pillow works great to keep pressure off while you’re sleeping. If you don’t have a travel pillow you can roll a clean cotton T-shirt or sheet up and place it around the ear so that when you lay on your side, there’s no direct pressure on your ear.
Should I take my piercing out if it’s infected?
When to remove a piercing
If a new piercing is infected, it is best not to remove the earring. Removing the piercing can allow the wound to close, trapping the infection within the skin. For this reason, it is advisable not to remove an earring from an infected ear unless advised by a doctor or professional piercer.
How do you heal an irritated piercing?
Gently pat dry the affected area with clean gauze or a tissue. Then apply a small amount of an over-the-counter antibiotic cream (Neosporin, bacitracin, others), as directed on the product label. Turn the piercing jewelry a few times to prevent it from sticking to the skin.
Is Neosporin safe for piercings?
NEVER USE: Bacitracin or Neosporin. Petroleum based ointments CLOG the piercing and make it difficult for your body to heal. NEVER USE Rubbing Alcohol, Hydrogen Peroxide, Claire’s ear care solution. These products are too strong and will irritate your skin and piercing.
Can I clean my piercing with just water?
To make sure the healing process goes as smoothly as possible, wash your hands before you touch your piercing or jewelry. Don’t soak your piercing in any water (other than saline solution) until it’s fully healed.
How do you clean piercings with antibacterial soap?
(ie, Phisoderm, Bactine, or liquid antibacterial soaps such as Dial, Lever 2000, or Softsoap) and avoid perfumed products. Dilute 50/50 with water if irritation occurs. Leave the cleanser on the skin for 3 minutes; lather and work the ring back and forth through the piercing half a dozen times.
